Message tester
Colour boxes:
{green}. Unknown characters show with a red outline.Selected character
All characters
Top half = front of flap n, bottom half = back of flap n−1. ! = clipped.
Single-module simulator
flap 0showing ␣target ␣
Click a character to roll to it. Like the real spool it only turns forwards. You can also type a key while this tab is open. Space = play/pause, → = step. Set the speed to 1–2 flaps/s to watch each flap fall.
Physical flaps (as printed)
Numbers match the objects in the 3MF. Left: top face. Right: bed face, seen from underneath. Hinge = bottom edge.
Export
Downloads flaps.3mf. Open it in Bambu Studio. The firmware list and config.yaml are on the Firmware & config tab.
Build plates
Same 4×5 grid as the export. Grey corner = bed exclusion zone, dashed = prime tower.
Sort printed flaps
Firmware flap list
Replace flaps[NUM_FLAPS] in scottbez1 firmware/src/config.h. Also written to output/firmware_flaps.h on export.
Config
Save keeps your edits in this browser only. Revert goes back to your last Save; Reset to default settings loads the settings this site ships with. To use your edits on the Mac, copy this into flaps/generator/config.yaml.